Stand with good posture and put the carton in the machine
Make sure to always wear the PBM earplugs in the Zone
Make sure to always wear the safety shoes in the Zone
Make sure to always wear the safety goggles in the Zone
Make sure to always wear the safety cap when you enter a machine
Make sure to always wear safety clothing
Watch out if you have to work at a certain height
Make sure the emergency button of the pallet is always aimed at yourself
Watch out for danger of burning when opening the glue supply of the OCME Traypacker
Always be careful if you have to work with several chemicals
Always be careful with danger of heat
Make sure you always detach the key from the switch of the roller
Make sure you do not cross the red line to avoid accidents
Watch out for turning parts of the machine (OCME) while attaching a new foil
Turn the lock to the left.
Inspect the machine to determine the required recipe.
Go to your workspace with the car. Take out the necessary spacers.
Take the current spacers out the machine.
Take the conductors out of the machine
Place the right conductors after taking these of the car
Place the prepared spacers with the help of a second operator.
Make sure the coloured text is placed on the side of the lock
Turn the locks to the right to tighten the spacers
Attach the lock for lock-out-take-out (LOTO)
Press on the screen of the machine on the parts that you will be working with
Press on the screen of the machine on the button 'loosen brake-lock'
Prepare your tools for use
Turn the fingers in the machine upwards by placing the unlocker and turning it to the left
Make sure the hollow side of the fingers is in line with the bulging of the can
Use the equipment to tighten the fingers
Check the correct settings for the fingers of the machine
Unlock setting point 1
Attach the turning wheel on the setting point and set it up properly
Place the center blocks, foil rods, spreading-conductors and tools in front of the machine
Loosen the screws on the center blocks and remove the center blocks from the machine
Unscrew the spreading-conductors and remove them from the machine
Unscrew the foil rod on both sides
Make sure to do this on the back side.
Slide the foil rods from the screws at the back of the machine
Adjust the foil rods to the correct position
Screw the foil rod tight
Place the correct spreading-conductors and screw these tight
Place the correct center blocks and screw these tight
this is a new step
step number two