• Divider

      • Assembly 2 extra parts together

        • Collect the required components for the job. Bring them to the work area

        • Assemble the parts

      • Assembly extra parts on the Divider

        • Check the correct settings for the fingers of the machine

        • Unlock setting point 1

        • Attach the turning wheel on the setting point and set it up properly

        • Place the center blocks, foil rods, spreading-conductors and tools in front of the machine

        • Loosen the screws on the center blocks and remove the center blocks from the machine

        • Unscrew the spreading-conductors and remove them from the machine

        • Unscrew the foil rod on one side

          Make sure to do this on the front side.

        • Slide the foil rods from the screws at the back of the machine

        • Adjust the foil rods to the correct position

        • Screw the foil rod tight

        • Place the correct spreading-conductors and screw these tight

        • Place the correct center blocks and screw these tight

        • Check the machine to see which recipe you need

    • Non-return valve

      • Dismantling the non-return valve

        • Bring the tools to the work station:

          1. Racoord key 
          2. screwdriver 
        • Turn the handle downwards to close the air supply valve

        • Unscrew the first nut of the non-return valve using the Racoord key

        • Unscrew the second nut of the non-return valve using the Racoord key

        • Unscrew the first nut of the non-return valve with your hand

        • Unscrew the second nut of the non-return valve with your hand

        • Pull the non-return valve to the right to detach it from between the pipes

        • Take the seal out of the valve with the screwdriver

        • Take out all the parts of the non-return valve one by one (4)

      • Re-assembling the non-return valve

        • Put all parts back one by one

        • Attach the non-return valve back by pushing it to the left between the pipes

        • Screw back with your hand the first nut of the non-return valve

        • Screw back with your hand the second nut of the non-return valve

        • Screw the first nut of the non-return valve using the Racoord key

        • Screw the second nut of the non-return valve using the Racoord key

        • Open back the air supply by turning the handle to the right

    • Supervisors checks

      • Check the performance

        • Follow the standards to complete Task 1.

        • Enter production order

        • Task 2 done according to standards