• Getting started

      • Safety Checks

        • Stand with good posture and put the carton in the machine

        • Make sure to always wear the PBM earplugs in the Zone

        • Make sure to always wear the safety shoes in the Zone

        • Make sure to always wear the safety goggles in the Zone

        • Make sure to always wear the safety cap when you enter a machine

        • Make sure to always wear safety clothing

        • Watch out if you have to work at a certain height

        • Make sure the emergency button of the pallet is always aimed at yourself

        • Watch out for danger of burning when opening the glue supply of the OCME Traypacker

        • Always be careful if you have to work with several chemicals

        • Always be careful with danger of heat

        • Make sure you always detach the key from the switch of the roller

        • Make sure you do not cross the red line to avoid accidents

        • Watch out for turning parts of the machine (OCME) while attaching a new foil

      • Prepare the machine

        • 1. Turn the lock to the left.

        • Inspect the machine to determine the required recipe.

        • Go to your workspace with the car. Take out the necessary spacers.

        • Take the current spacers out the machine.

        • Take the conductors out of the machine

        • Place the right conductors after taking these of the car

        • Place the prepared spacers with the help of a second operator.

        • Make sure the coloured text is placed on the side of the lock

        • Turn the locks to the right to tighten the spacers

        • Loosen the spacer

      • Prepare divider

        • Attach the lock for lock-out-take-out (LOTO)

        • Press on the screen of the machine on the parts that you will be working with

        • Press on the screen of the machine on the button 'loosen brake-lock'

        • Prepare your tools for use

        • Turn the fingers in the machine upwards by placing the unlocker and turning it to the left

        • Make sure the hollow side of the fingers is in line with the bulging of the can

        • Use the equipment to tighten the fingers

        • Check the correct settings for the fingers of the machine

        • Unlock setting point 1

        • Attach the turning wheel on the setting point and set it up properly

        • Place the center blocks, foil rods, spreading-conductors and tools in front of the machine

        • Loosen the screws on the center blocks and remove the center blocks from the machine

        • Unscrew the spreading-conductors and remove them from the machine

        • Unscrew the foil rod on both sides

          Make sure to do this on the back side.

        • Slide the foil rods from the screws at the back of the machine

        • Adjust the foil rods to the correct position

        • Screw the foil rod tight

        • Place the correct spreading-conductors and screw these tight

        • Place the correct center blocks and screw these tight

        • this is a new step 

        • step number two