• Preparing the Frenzy 205P for use

      • Inflating the tires

        • Remove the valve cap

        • Put the pump head on the valve

        • Pump until the tire is at the right pressure

        • Put the valve cap back on

        • Repeat the process for the other tire

    • Riding the Frenzy 205P

      • Starting to ride

        • Grab the handle bars with your hands

        • Place one foot on the ground and one on the deck

        • Kick your foot backwards besides the scooter to give motion

        • Repeat kicking to maintain motion

        • Place the heel of your kicking foot on the brake block above the rear wheel to brake

      • Folding the scooter

        • Open the release cap

        • Push down the handle bar

        • Close the quick release clamp

        • Remove the handle bars and store them

        • Pull the lock mechanism upwards and bend the bar

        • Fold the scooter bar backwards

        • Pick up the scooter by the strap

      • Assembling the scooter

        • Take the scooter out of the box

        • Place your finger in the lock mechanism and pull upwards

        • Pull the bar upwards until the stop is reached and then release the lock mechanism

        • Insert the handle bar grips into the T-section of the handle bar  

        • Check if the handle bars are properly locked

        • Loosen the quick release clamp on the handle bar by pushing it to the left 

        • Pull the handle bars upwards until the desired height is reached

        • Ensure the locking pin is locked in the right place on the front of the handle bars

        • Re-lock the quick release clamp

        • Make sure to inflate the tires before using the scooter

          The tires are only 50% inflated before transport.

      • Fahren mit dem scooter

        • Man steigt mit dem rechten Fuss auf den Scooter.

    • Maintaining the Frenzy 205P

      • Changing the wheels

        • Use the 5mm to loosen the axe

        •  Remove the axe

        • Take out the old wheel and refit a new one

        • Tighten the axe with the 5mm